Lifting My Dyna’s a Pain in the Ass

Lifting my Dyna’s a pain in the ass.

On most bikes you simply lift from under the parallel frame members and get to work. But in this case three of four contact points are at one height and one is a fair bit lower.

Service Lift Adapter. Click for larger image.

Sure, you can cut up some 2×4 blocks to fit. But when I bought the bike I took the easy way out and bought the gen-you-wine H-D Service Lift Adapter. WTF, it was only $25 or so and offered some distinct advantages over crude wood blocks. See image.

So where am I going? Oh, yeah, the night before Biketoberfest I needed to change out a rear tire. When I finished I dropped the bike to the floor, kicked the tools aside, and went inside to eat. This tire change was unscheduled work and we were hungry. The burgers off the grill tasted oh, so good.

The next morning we were off and a fine weekend was had by all.

Some days later I was cleaning up the tools and discovered that two of the four Lift Adapter parts were missing. I scoured the shop – nope, they were gone. I was about to give up when Pam suggested checking the bike. “Uh huh, yeah, right,” I thought, “it’s been hundreds and hundreds of miles, if I’d left ’em in place they’d have fallen off, long gone fer sure.” But I looked anyway and waddya know, there they were!

So, it’s product endorsement time. Service Lift Adapter # 98965-99 is easy to place, exactly the right size for the job, and grips the frame members well enough that they’re hard to lose. Not that I’d recommend ridin’ with ’em in place. But if you do, perhaps after the stress of some unscheduled work, they probably won’t fall off at the wrong moment, maybe hurting you in the process. Two thumbs up.

[Tip o’ the ol’ lid to Marjorie over at Thunder Press for catchin’ my transposition of a couple o’ digits in the part number!]

Share this:

Leave a Reply

Your email address will not be published. Required fields are marked *